Patent application number | Description | Published |
20080297082 | DRIVE CONTROL DEVICE OF MOTOR AND A METHOD OF START-UP - A drive control device of motor capable of starting up even a motor of such a type that the polarity of induced voltage does not switch every 180° of electrical angle or the polarity, positive or negative, does not occur with accuracy without causing a reverse rotation is provided. In a start-up control of motor, the following operation is performed: a current is passed through any coils in two phases, and the polarity of voltage induced in the non-conducting phase is detected. A conducting phase at start-up is determined based on the detected polarity of induced voltage. The average value of induced voltages in non-conducting phase detected with respect to the coils in respective phases is determined. The average value and the detected induced voltages are compared with each other, and relative polarities are determined from the magnitude relation with the average value to determine a conducting phase at start-up. | 12-04-2008 |
20090200971 | DRIVE SYSTEM OF SYNCHRONOUS MOTOR - A drive system of a permanent magnet motor is constituted of a mode switching trigger generator which monitors a state of a permanent magnet motor and issues a mode switching trigger, a conduction mode determining unit which receives the mode switching trigger and switches the mode of the permanent magnet motor, and a PWM generator which outputs a PWM signal to an inverter in accordance with the output of the conduction mode determining unit. The mode switching trigger is generated on condition that the speed electromotive force of the permanent magnet motor exceeds a constant or variable threshold value. | 08-13-2009 |
20100066284 | DRIVE SYSTEM OF SYNCHRONOUS MOTOR - A position sensorless drive method capable of driving a permanent magnet motor by an ideal sine-wave current and enabling the driving from an extremely low-speed range in the vicinity of zero-speed is provided. A neutral-point potential of the permanent magnet motor is detected in synchronization with a PWM waveform of an inverter. The position of a rotor of the permanent magnet motor is estimated from the variation of the neutral-point potential. Since the neutral-point potential is varied in accordance with the magnetic circuit characteristics of an individual permanent magnet motor, the position can be detected regardless of the presence of saliency of the permanent magnet motor. | 03-18-2010 |
20110074324 | Control Device for Synchronous Motor - A control technology for a synchronous motor for suppressing rotational pulsation caused by variation in individuals without making a control algorithm complex is provided. In a motor drive system which is a control device for a synchronous motor, in order to suppress the pulsation component of N times as high as the AC frequency for driving the synchronous motor, a controller in which the phase property of the disturbance response of the controller with respect to the pulsation frequency is within ±45° is arranged. Therefore, the torque pulsation component generated from distortion in induction voltage or variation between phases is suppressed. | 03-31-2011 |
Patent application number | Description | Published |
20090072773 | MOTOR DRIVING APPARATUS AND METHOD FOR CONTROL OF MOTOR REVOLUTION - This invention provides a motor driving apparatus that made it possible to reduce torque ripples including those attributed to load variation of the motor and an associated method for control of motor revolution. An output stage to a multiphase DC motor is comprised of power elements to supply output voltages to multiphase coils and a predriver to supply drive voltages to the power elements. A resistor means detects a current flowing through the power elements. A supply current detector detects a voltage signal produced across the resistor means as a supply current, using a high-speed ADC and a moving average filter. An output controller generates a PWM signal with a frequency lower than the frequency of the high-speed ADC so that the current detected by the supply current detector conforms to a current signal indicating a motor revolving speed and transfers the PWM signal to the output stage. | 03-19-2009 |
20090080115 | VCM DRIVER AND PWM AMPLIFIER - The present invention provides a VCM driver realizing low power consumption and high accuracy and a PWM amplifier compensating a dead time distortion. A phase compensator, a ΔS modulator receiving an output signal of the phase compensator and converting the output signal to a control code of predetermined bits, a PWM modulator receiving the control code to produce a PWM signal, and an output circuit receiving the PWM signal to drive a voice coil constitute a forward path. A sense amplifier sensing a current of the voice coil, an ADC receiving an output signal of the sense amplifier, a low-pass filter receiving an output signal of the ADC, and a decimation filter receiving an output signal of the low-pass filter constitute a feedback path. An output signal of the decimation filter is fed back to the input side of the phase compensator to form a major feedback loop having a first-order characteristic loop gain. An output signal of the decimation filter is fed back to the output side of the phase compensator to form a minor feedback loop having a loop gain which is flat until a target band frequency when viewed from the output side of the phase compensator. | 03-26-2009 |
20090212851 | POWER SUPPLY UNIT - High-accuracy overcurrent detection is performed, while a loss resulting from the current detection is significantly reduced. A switch section outputs the voltage between the both terminals of a current detection resistor using an AND signal between an output signal from a hysteresis comparator and an output signal from a pre-driver. The voltage is filtered by an electrostatic capacitor element and a resistor, and inputted to a comparator. The comparator makes a comparison between the signals inputted to the two input terminals thereof, and outputs the result of the comparison to a digital filter. When an overcurrent begins to flow in a power supply unit, the levels of the voltages inputted to the two input terminals of the comparator are inverted so that the comparator outputs an inversion signal to the digital filter. The digital filter outputs a detection signal to an overcurrent detection circuit when an arbitrary time has elapsed. | 08-27-2009 |
20100177444 | VCM DRIVER AND PWM AMPLIFIER - The present invention provides a VCM driver realizing low power consumption and high accuracy and a PWM amplifier compensating a dead time distortion. A phase compensator, a ΔΣ modulator receiving an output signal of the phase compensator and converting the output signal to a control code of predetermined bits, a PWM modulator receiving the control code to produce a PWM signal, and an output circuit receiving the PWM signal to drive a voice coil constitute a forward path. A sense amplifier sensing a current of the voice coil, an ADC receiving an output signal of the sense amplifier, a low-pass filter receiving an output signal of the ADC, and a decimation filter receiving an output signal of the low-pass filter constitute a feedback path. An output signal of the decimation filter is fed back to the input side of the phase compensator to form a major feedback loop having a first-order characteristic loop gain. An output signal of the decimation filter is fed back to the output side of the phase compensator to form a minor feedback loop having a loop gain which is flat until a target band frequency when viewed from the output side of the phase compensator. | 07-15-2010 |
20110063021 | POWER SUPPLY UNIT - High-accuracy overcurrent detection is performed, while a loss resulting from the current detection is significantly reduced. A switch section outputs the voltage between the both terminals of a current detection resistor using an AND signal between an output signal from a hysteresis comparator and an output signal from a pre-driver. The voltage is filtered by an electrostatic capacitor element and a resistor, and inputted to a comparator. The comparator makes a comparison between the signals inputted to the two input terminals thereof, and outputs the result of the comparison to a digital filter. When an overcurrent begins to flow in a power supply unit, the levels of the voltages inputted to the two input terminals of the comparator are inverted so that the comparator outputs an inversion signal to the digital filter. The digital filter outputs a detection signal to an overcurrent detection circuit when an arbitrary time has elapsed. | 03-17-2011 |
20110156625 | MOTOR DRIVING APPARATUS AND METHOD FOR CONTROL OF MOTOR REVOLUTION - This invention provides a motor driving apparatus that made it possible to reduce torque ripples including those attributed to load variation of the motor and an associated method for control of motor revolution. An output stage to a multiphase DC motor is comprised of power elements to supply output voltages to multiphase coils and a predriver to supply drive voltages to the power elements. A resistor means detects a current flowing through the power elements. A supply current detector detects a voltage signal produced across the resistor means as a supply current, using a high-speed ADC and a moving average filter. An output controller generates a PWM signal with a frequency lower than the frequency of the high-speed ADC so that the current detected by the supply current detector conforms to a current signal indicating a motor revolving speed and transfers the PWM signal to the output stage. | 06-30-2011 |