Vintomie Networks B.V., LLC Patent applications |
Patent application number | Title | Published |
20130013658 | USE OF LINE CHARACTERIZATION TO CONFIGURE PHYSICAL LAYERED DEVICES - A method of optimizing filter performance through monitoring channel characteristics is provided. A signal enters a channel and a receiver receives the signal. The receiver includes a FIR filter to remove near-end transmitted interference and recover a far-end desired signal. The filter has storage elements configured as a shift registers to move the signal, multipliers to multiply the signal by a filter coefficient, an intermittent summer to combine the multiplied results into a replica of an interfering signal, a final summer to remove the replica from the receiver signal to provide direct and indirect monitoring of the signal, where direct monitoring includes time or frequency monitoring, and indirect monitoring includes monitoring signal to noise ratio, error magnitude or bit error rate. The filter is optimized according to monitoring and includes reducing a dynamic range, reducing bits of precision, reducing linearity, the filter, and reallocating the filter. | 01-10-2013 |
20120155342 | HYBRID FREQUENCY COMPENSATION NETWORK - Hybrid frequency compensation is provided. Hybrid circuits are used to subtract the transmit signal from the receive signal in a full duplex communication system. Since the hybrid circuit and the main line driver are exposed to different loads, accurate subtraction is difficult to achieve. A frequency dependent network is used to match the loading seen by the driver and the hybrid. The compensation network can be based on active and/or passive components. | 06-21-2012 |
20110193536 | 10GBASE-T TRAINING ALGORITHMS - A method of identifying and correcting each of the changes that may occur with wire pairs between the transmitter and receiver in Ethernet 10GBase-T cabling is provided. The method includes four wire pairs A, B, C and D, a polarity swapping and scrambler state machine that determine if the chosen pair matches the requirements for pair A. A slave Tap state machine generates a rule for correct B, C and D patterns based on a pair chosen as pair A. The cables B, C and D are iteratively swapped to rearrange the pair mapping into the polarity swap state machine, and a deskew state machine identifies the latency difference between the different pairs. If the rules are not satisfied, a new pair A is designated at the swapping state machine and the process is repeated until the rules are satisfied. | 08-11-2011 |
20110141875 | COMBINED ECHO AND CROSSTALK CANCELLATION - Combined echo and crosstalk cancellation is provided. Frequency domain adaptive filters are used to remove or reduce the effects of echo and crosstalk for a multi-channel and full-duplex communications system. Data from each transmit channel is buffered and converted to the frequency domain. The frequency domain data is multiplied by crosstalk coefficients to obtain a frequency domain correction signal for each channel. Adaptation of the crosstalk coefficients is based on correlations between the error signals and the data from each of the transmit channels. A single frequency domain transform engine, such as a Fast Fourier Transform engine, is employed for all calculations to save power and area. | 06-16-2011 |